Energy UNITS FOR LIFT TABLE 1
Basic Description
This electrical power unit is designed exclusively for your modest lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become extensively applied while in the market of logistic devices like minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled through the solenoid valve together with the velocity managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This power unit is designed solely for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the speed controlled from the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is reduce, the decreasing motion is controlled through the manual override perform.
Power UNITS FOR LIFT TABLE three
General Description
This power unit is designed exclusively for your significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve plus the speed controlled by a strain compensated movement handle valve.
Power UNITS FOR LIFT TABLE 4
Basic Description
This energy unit is developed solely for that significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as the pace controlled by the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is reduce, the reducing motion is controlled through the manual override function.
Exclusive Notes
1. This energy unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned just before installation of the power unit.
three. Viscosity with the oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
four. Oil transforming is required immediately after the preliminary one hundred operation hours,afterwards after each and every 3000 hrs.
five. The electrical power unit proven is built to be mounted vertically.