Material Managing Energy UNIT one
Basic Description
This power unit is built for your fork lift field, consisting of highly effective gear pump, DC motor, manual raise and lower valve, tank, ect. The up and down motion are controlled through the lever from the guide release valve, that’s outfitted with an electrical switch to activate the motor. The lowing speed is controlled through the stress compensated movement control valve.
Special Notes
one. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean the many hydraulic parts concerned ahead of installation of the energy unit.
three. Viscosity on the hydraulic oil shoud be 15~46 cst, which need to also be clean and free of impurities, N46 hydraulic oil is suggested .
4. Oil transforming is required following the preliminary one hundred operation hrs, afterwards when just about every 3000 hours.
5. The electrical power unit shown is created to be mounted horizontally.

Materials Dealing with Electrical power UNIT 2
Standard Description
This energy unit options electrical power up gravity down circuit. Activate the get started solenoid to start out the motor to lift the machine. The lowing movement is activated through the solenoid valve using the lowering speed managed by the pressure compensated movement control valve. Goods of this series can be widely utilized in the market of logistic devices including fork lift, mini lift table, and so forth.
Distinctive Notes
one. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic parts concerned in advance of mounting the electrical power unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst,which need to also be clean and free of impurities, N46 hydraulic oil is advised .
four. Oil modifying is needed immediately after the initial one hundred operation hrs,afterwards after just about every 3000 hrs.
5. The electrical power unit should be mounted horizontally.